Canopy lighting for reef tank

Discussion on aquatic lighting.

Moderators: snoopdog, Amphiprion, AgeDynasty

Post Reply
User avatar
caymanada
Amoeba
Posts: 20
Joined: Sat Jul 08, 2006 9:02 pm
Location: West Mobile

Canopy lighting for reef tank

Post by caymanada » Sat Mar 30, 2013 9:42 am

Looking for suggestions - I have a 100 gal (60 x 18 x 20) tank that was setup for freshwater, but I am thinking about setting it up as a reef tank. The biggest concern that I have is lighting. I want to mount the lighting in the wooden canopy that matches the stand. What type of lighting (MH, LED, T5, etc.) is best for mounting in the canopy on a reef tank? Brand? Wattage? Wavelength/color? Anybody out there with a similar setup?

rich850
Amoeba
Posts: 118
Joined: Sun Apr 10, 2011 12:56 am
Are you a Bot ?: No

Re: Canopy lighting for reef tank

Post by rich850 » Mon Apr 01, 2013 12:05 am

There is not really a right answer to this question its based on opinion I have grown coral under a 6 bulb t 5 ATI fixture I had pretty good results I tried a couple led fixtures I have grown coral under metal halides I have seen more sps growth with metal halides I think LEDs have great color options I am pretty set on a combo of metal halides and LEDs but I have to say I have not seen a tank of the month on reefcentral with LEDs yet but I have seen a zoanthid dominate tank with LEDs but all this being said when it comes to metal halides as long as you get a good reflector with a bulb of your liking you are good to go ...with t5s I think you should go with an ATI fixture they are more expensive but you get what you pay for...with LEDs I am impressed by ecotechs product and with the DIY LEDs I haven't been impressed with other fixtures you really get what you pay for with lighting I bought used electronic ballasts for my halides some magnetic ballasts are great I just can't afford the power hope this helps

User avatar
caymanada
Amoeba
Posts: 20
Joined: Sat Jul 08, 2006 9:02 pm
Location: West Mobile

Re: Canopy lighting for reef tank

Post by caymanada » Tue Apr 02, 2013 4:46 pm

Thank you for your opinion/advice. Is there a potential problem of putting halides in a canopy and the heat getting too much...or is that just my misconception? Regardless of the type of lighting, any particular combination of colors (i.e. - actinic, 10K, 12K, 14K, 20K, etc.) work best? I have to say, the Ecotechs attention to PAR distribution is the thing that most impresses me about them. I haven't found another brand that can compare to it.

rich850
Amoeba
Posts: 118
Joined: Sun Apr 10, 2011 12:56 am
Are you a Bot ?: No

Re: Canopy lighting for reef tank

Post by rich850 » Sat Apr 06, 2013 2:19 am

I run halides in my canopy ...heat can always be combated with fans or a chiller depending on what your house temperature is if you were going with radions you would probably need 4 of them they say they cover a 30 in spread but I am going off of what I have seen not the sales pitch as far as metal halides I am running 14k bulbs and adding LEDs to get the color I want but the 20k bulbs produce a nice color as a stand alone bulb

wodom86
Amoeba
Posts: 4
Joined: Sat Dec 21, 2013 8:21 am
Are you a Bot ?: No

Re: Canopy lighting for reef tank

Post by wodom86 » Sat Dec 21, 2013 9:09 am

on my 120 i found screws that fit where the radion hanging kit screw into the radion, then i drilled holes in the top in the right spot. ran the bolts through the canopy attached radions :) now you cant tell i have them attached... and if you want to angle them just add a few washers to the direction you wish to angle them. hope this helps... ill post a picture of my canopy with the doors open later

Post Reply