Fan Hole

Post by **snoopdog** » Sun May 18, 2003 7:37 pm

I hated to do it but went ahead and measured out for fans. Here goes, step by step pics.

ShagMan · Post by **ShagMan** » Mon May 19, 2003 7:15 am

Good job with the jigsaw!!! Kevin, you know, you could have driven 2 miles down the road and borrowed my holesaw set and 18v cordless drill

Seriously, good to see you and amy going for the canopy fan, it'll help the water temps a LOT... just make sure you have LOTS of surface ripple for gas exchange/cooling of the water.

Amyjoe · Post by **Amyjoe** » Mon May 19, 2003 7:51 am

Bah... he had to tie me up in the closet to do, I was kicking and screaming the whole time....

Scott · Post by **Scott** » Mon May 19, 2003 12:24 pm

My wife does that anytime I do anything around the house that I could really mess up. It makes me more nervous so what she is doing is counter productive.

In this case I would have said "If you have a problem, stick in in your fan hole and leave me alone!"

Scott

Post by **snoopdog** » Mon May 19, 2003 3:02 pm

I have a Dewalt 18volt cordless, just wanted to try the Dremel out, its new.

SaltnLime · Post by **SaltnLime** » Mon May 19, 2003 8:11 pm

Amyjoe wrote:Bah... he had to tie me up in the closet to do, I was kicking and screaming the whole time....

"bites his tongue"

SaltnLime · Post by **SaltnLime** » Mon May 19, 2003 8:12 pm

snoopdog wrote:I have a Dewalt 18volt cordless, just wanted to try the Dremel out, its new.

Nice job... I know it killed you to have to do it....