newbie builds his first sump
Posted: Sat Feb 11, 2006 10:02 pm
I have been working on building a sump for my 125 for quite some time. I had some trouble with the dimensions at first because the entire thing had to fit under my stand. This meant it had to be less than 16" wide. I bought a "tidepool" wet/dry filter and sump for $25 from one of the guys locally. I figured that that was not enough volume so I also got a rubbermaid container and connected it to the tidepool with 2 bulkhead connectors and some 2" hose. I tried to glue some baffles into it but could not get them to stick. Instead I bought 2 samller containers and sat them one inside the other. The outer one is taller than the high water level and has holes cut in the bottom side opposite from where my skimmer will be going. The height of the innermost container is set to prevent overflowing the tank incase I loose suction on the overflow box. I built the overflow box myself. I used 2 tupperware containers. I cut up the lid from the large container to make a holder for the two sides of the overflow.
This being the first one I have ever built I am very happy with it. My wife was terified that I would flood the living room, but so far not a drop. Below is a drawing of the design and some snapshots of the actaul installation.
Look it over and let me know what you think. Or if you see something I missed please tell me.
This being the first one I have ever built I am very happy with it. My wife was terified that I would flood the living room, but so far not a drop. Below is a drawing of the design and some snapshots of the actaul installation.
Look it over and let me know what you think. Or if you see something I missed please tell me.