I hated to do it but went ahead and measured out for fans. Here goes, step by step pics.
Fan Hole
Moderator: snoopdog
- snoopdog
- Yellow Tang
- Posts: 4258
- Joined: Mon Feb 17, 2003 7:37 pm
- Are you a Bot ?: No
- Location: Mobile, Al
- Contact:
Fan Hole
"When they was no meat we ate fowl, when there was no fowl we ate crawdad. And when there was no crawdad to be found, we ate sand."--Cellmate
"You ate what?"--H.I.
"We ate sand."--Cellmate
"You ate sand?"--H.I.
"That's right."--Cellmate
"You ate what?"--H.I.
"We ate sand."--Cellmate
"You ate sand?"--H.I.
"That's right."--Cellmate
Good job with the jigsaw!!! Kevin, you know, you could have driven 2 miles down the road and borrowed my holesaw set and 18v cordless drill Seriously, good to see you and amy going for the canopy fan, it'll help the water temps a LOT... just make sure you have LOTS of surface ripple for gas exchange/cooling of the water.
-Josh Murrah
- snoopdog
- Yellow Tang
- Posts: 4258
- Joined: Mon Feb 17, 2003 7:37 pm
- Are you a Bot ?: No
- Location: Mobile, Al
- Contact:
I have a Dewalt 18volt cordless, just wanted to try the Dremel out, its new.
"When they was no meat we ate fowl, when there was no fowl we ate crawdad. And when there was no crawdad to be found, we ate sand."--Cellmate
"You ate what?"--H.I.
"We ate sand."--Cellmate
"You ate sand?"--H.I.
"That's right."--Cellmate
"You ate what?"--H.I.
"We ate sand."--Cellmate
"You ate sand?"--H.I.
"That's right."--Cellmate